cpfitalia forum

It has been added some knurling on the appearence basis.


Brief description:
Model No.: XENO S3A V2
Material: Type-III Hard-anodized Al-alloy, Gun gray
Reflector: OP
Clip: detachable 360 degree encircled pocket clip
Tail-cap strike bezel: stainless steel( can stand up at tail)
Output: Normal output modes: High-low-ultra low
Hidden functional modes: the sequence:Strobe-SOS-Local Beacon (half-press more than 3 times on any normal mode, u will enter into hidden functional modes)
Max output: 300lms(Cree XM-L 1B U2)/1000mA
Max burning time: 100hours
Switch: reverse clicky switch
Battery:18650*1 Li-ion rechargeable battery or CR123A*2
Size: Diameter 21.5, length: 111mm
Net Weight: 50g
Standard spare parts: O-rings*2 and Switch*1

Hello, We need any link please

Thanks.

P.P. ha scritto:Hello, We need any link please

Thanks.

Hi p.p,

Still not any update for other website now.

Model No.: XENO S3A
Material: Type-III Hard-anodized Al-alloy, Gun gray
Reflector: OP
Clip: XENO unique 360 degree encircled pocket clip: a highly reliable engineering design,detachable
Tail-cap strike bezel: XENO unique stainless steel tail plug
Output: Normal output modes: low-ultra low-High
Hidden functional modes: the sequence:Strobe-SOS-Local Beacon (half-press more than 3 times on any normal mode, u will enter into hidden functional modes)
Max output: 300lms(Cree XM-L 1B U2)/1000mA
Max burning time: 100hours
Switch: reverse clicky switch
Battery:18650*1 Li-ion rechargeable battery or CR123A*2
Size: Diameter 21.5, length: 111mm
Net Weight: 50g
Standard spare parts: O-rings*2 and Switch*1

It has still the diameter of the V1?

XENOLEDLywin ha scritto:Hi p.p,

Still not any update for other website now.
I just get the first photo and post here immediately.

Thanks.

alfapad ha scritto:It has still the diameter of the V1?

Hi Alfapad, Yes, It has the same diameter with V1.

But why only 1A and not 1,5 or 2 amps? For the heat? Because that way it is bright as a xpg flashlight

alfapad ha scritto:But why only 1A and not 1,5 or 2 amps? For the heat? Because that way it is bright as a xpg flashlight

Fully agree!

Better than most drivers:
1A
2A
3A timer 30 sec. after return to 2A

In this forum we would buy 50... So instead they take zero!

Perhaps is possible to make a small series only for this community. With a 2A driver (or 3A with a step regulation, like said by Torch) and a custom lettering

2.5A + neutral tint = win!